LibertyKite® – A kite wing to tow your boat
Invented by Yves Parlier, the LibertyKite® is a stable auto kite of 10 to 20m² for the traction of boats from 4 to 18 meters. Connected to the boat by two lines attached to the mooring cleats, the LibertyKite® is an innovative, fun and easy-to-use solution.
Safety at sea
Join the coast in case of dismasting or engine failure.
Fuel economy
Turn off the engine and enjoy a clean, noiseless and odorless navigation.
Navigation
Do yourself a favor ! A quick solution to install and not requiring any special knowledge in sailing or kitesurfing.
The LibertyKite® uses wind as the only energy source to provide you with greater range of navigation, fuel economy and safety.
LibertyKite: freedom in three steps!



The launch
______________
The LibertyKite can be launch in 4 main phases. First, the swelling of the wing: locate the air inlets and present them perpendicular to the wind. Secondly, hold the LibertyKite by the leading edge and pull on the trailing edge and then fly the shorter part of the leading edge between one hand and the nearest clew point. Third, gradually release the canvas at ear level. Finally, give some slack in the lines by leaving more length at the back of the boat so that the LibertyKite pulls well forward.



The settings
_________________________
For LibertyKite to be stable, it is important that the two lines are substantially parallel. If the boat pulls too far to port or starboard, moving the lines backwards and downwind will make the boat want to go upwind (luff), tie them more to the wind and allow them to go down towards the wind. From there, you have to find the right balance for the boat. Depending on the wind, we will choose two attachment points on the front and rear boat, more or less offset laterally (ten degrees). It is interesting to have the front line attachment slightly more upwind to help the kite have an upward yaw angle. The complete and schematic user manual is delivered with the LibertyKite.



The recovery
________________________________
To recover, simply drop one of the lines and then recover the LibertyKite. Another method is to prevent the wing from falling into the water when the wind is light: simply orient the boat to the wide beam in order to position the LibertyKite as far as possible above the boat. Take the back line again for a vertical passage of the LibertyKite. Then recover the front line and then the canvas from the front ear and choke the LibertyKite (method to be applied quickly so that the wind does not blow back into the kite).
LibertyKite : la liberté en trois étapes

L’envoi
______________


L’envoi du LibertyKite peut se décomposer en 4 grandes phases. Premièrement, le gonflement de l’aile : repérer les entrées d’air et les présenter perpendiculairement au vent. Deuxièmement, tenir le LibertyKite par le bord d’attaque et tirer sur le bord arrière puis faire voler la partie du bord d’attaque plus courte entre une main et le point d’écoute le plus proche. Troisièmement, lâcher progressivement la toile au niveau des oreilles. Enfin, donner du mou dans les lignes en laissant plus de longueur à l’arrière du bateau afin que le LibertyKite tire bien vers l’avant.

Les réglages
_________________________


Pour que LibertyKite soit stable, il est important que les deux lignes soient sensiblement parallèles. Si le bateau tire trop vers bâbord ou tribord, reculer l’attache des lignes et les déplacer sous le vent donnera l’envie au bateau de remonter vers le vent (lofer), les attachera plus au vent et permettra de descendre vers le vent. A partir de là, il faut chercher le bon équilibre du bateau. En fonction du vent on va choisir deux points d’attache sur le bateau avant et arrière, plus ou moins décalés en latéral (dizaine de degrés). Il est intéressant d’avoir l’attache de la ligne avant légèrement plus au vent pour aider le Kite à avoir un angle de lacet vers le haut. La notice exhaustive et schématisée d’utilisation est livrée avec le LibertyKite.

La récupération
________________________________


Pour la récupération, il faut tout simplement lâcher une des lignes puis récupérer le LibertyKite. Une autre méthode permet d’éviter à l’aile de tomber à l’eau lorsque le vent est faible: il suffit d’orienter le bateau au grand largue afin de positionner le LibertyKite le plus possible au dessus du bateau. Reprendre la ligne arrière pour un passage à la verticale du LibertyKite. Puis récupérer la ligne avant puis de la toile à partir de l’oreille avant puis étouffer le LibertyKite (méthode à appliquer rapidement pour pas que le vent ne se ré-engouffre dans le Kite).

Navigate in complete safety
Safety instructions
The use of this equipment requires special precautions and compliance with basic safety instructions:
- Check the weather before sailing
- Put on gloves
- Never use this product in stormy weather
- Always beware of waves, swells and strong winds.
It is imperative to read the operating instructions and safety precautions carefully before using the LibertyKite.